Optical Fiber Categories

Optical Fiber Categories

Here’s the most common description of the varieties of telecommunication fibers.

MMF (multimode fiber)
- OM1 or MMF(62.5/125)
- OM2/OM3 (G.651 or MMF(50/125))
SMF (single-mode fiber)
- G.652 (dispersion non-shifted SMF)
- G.653 (dispersion shifted SMF)
- G.654 (cut-off shifted SMF)
- G.655 (NZDSF)
- G.656 (low dispersion slope NZDSF)
- G.657 (bending insensitive SMF)

Technically you can use any fibers for FTTx as far as the optical budget allows, but the most common application for FTTx shall be by G.652 and G.657.

G.651 (multi mode fiber)

Multi mode fiber (MMF) is used for communication over short distance, such as LAN and datacenter. MMF classified M1 to M4 according to ISO/ IEC. Each bandwidth and distance is defined as follows.

ITU-T G.651 is another name for OM2/OM3 or MMF(50/125). ITU-T recommendation does not have OM1 or MMF(62.5/125) which is still popular in US. The core of MMF(50/125) has a refractive index profile gradually changing from the center of the core to the cladding, which enables multiple of transmission light (mode) travel with nearly the same velocity.

G.652 (dispersion non-shifted SMF)

It is the most common SMF in the world. It is tuned to minimize the dispersion (which gives the deformation to the signal) around the wavelength at 1310nm. You can use 1550 nm wavelength window for the shorter distance or with the dispersion compensating fiber or module. G.652A/B is the basic SMF and G.652C/D is the category for Low-waterpeak SMF.

G.653 (dispersion shifted fiber)

It is designed to minimize the dispersion at around 1550nm where the optical loss is the smallest.

G.654 (cut-off shifted fiber)

Official name for G.654 is “cut-off shifted fiber”, but it is better known as low attenuation fiber. Sumitomo’s Z Fiber™ has the world record of 0.154 dB/km. Thanks to this low attenuation the major application for G.654 is in the submarine and terrestrial long-haul application such as 400km reach without repeater.

G.655 (NZDSF)

NZDSF is short for NZDSF for wide band transport fiber. G.653 has designed to have zero dispersion at 1550nm, but G.655 has positive or negative dispersion intently. The reason for that is to reduce the undesirable effect of the non-linear phenomenon which interfere with the adjacent wavelength in DWDM system. The first generation NZDSF such as PureMetroTM has smaller dispersion of around or less than 5ps/nm/km to make the dispersion compensation easier. On the other hand the second generation NZDSF such as Pure- Guide® has larger dispersion of around 10ps/nm/km to enhance the DWDM capacity to double.

G.656 (low-slope dispersion NZDSF)

It is a kind of NZDSF which has stricter requirements on the dispersion slope which enables to guarantee the DWDM performance in wider wavelength range.

G.657 (bending insensitive fiber)

This category is introduced to specify macrobending performance, which sports implementation in FTTH and access network. G.657.A is fully compliant with ITU.T-G.652 specification, on the other hand, G.657.B is required higher macrebending performance but not necessary to comply with G.652.